IWC Portugieser Automatic 42 QC: power reserve at 3, small seconds at 9 and the case

The Portugieser Automatic 42 is the three-hand Portugieser with the long power reserve, not the chronograph. Its dial is built very symmetrically, and that symmetry is what you check first in QC photos.

This is how the original looks according to the reviews (current generation, references IW5017xx):

  • Layout: power-reserve indicator at 3, small seconds at 9, date at 6; the date replaces the numeral there.
  • Dial: lacquered, with a deep gloss; the two subdials are recessed, cut into the lacquer and the brass base; applied Arabic numerals, leaf-shaped hands.
  • Case: 42.4 mm diameter, about 13 mm thick (one report gives 12.9 mm), around 48 mm lug to lug; sapphire glass front and back; water-resistant to 50 m.
  • Movement: calibre 52011, 28,800 vph, 168 hours (7 days) of reserve, Pellaton winding.

[[PHOTO: Portugieser Automatic 42 frontal bei weichem Tageslicht, Pfeile auf die Gangreserve-Anzeige bei 3, die kleine Sekunde bei 9, das Datum bei 6 und die aufgesetzten arabischen Ziffern]]

Not sure about a QC? Create an account and ask the community.

Editorial summary, not independently verified.

Quick question: in my QC photos the small seconds looks a bit larger than the power reserve. Is that already a flaw?

Measure cleanly first, before judging. On the original the two subdials should make the dial look symmetrical. Checks on the photo:

  • Same size and same height: an imaginary line from 9 to 3 should run through both centres.
  • Same distance to the edge and to the centre on both sides.
  • Recessed rims: the edge of the subdials should be even and clean.

Important: the photo must be exactly straight-on. Even a slight angle can make one subdial look larger than the other. So ask for a straight photo first, then compare.

Got it. And what about the date window? I can see a thin rim there.

Good observation, and not an automatic flaw. A review describes exactly that on the original: the lacquer layer is thick, and around the date window a visible lacquer rim remains under magnification, hard to see on dark dials. A fine, even rim is therefore normal. What to look at:

  • the window straight and centred under the centre;
  • the date numeral centred in the window;
  • no lacquer runs or dust inclusions around it.

One report mentions 15 coats of lacquer for these dials. That is why they reflect so strongly: a photo without flash and without a lamp directly above is essential here.

[[PHOTO: Nahaufnahme des Datumsfensters bei 6 und der vertieften kleinen Sekunde bei 9, Pfeile auf den Lackrand, die Ausrichtung des Fensters und die Kante des Hilfszifferblatts]]

On the case:

  • Thickness: about 13 mm; a side photo with a calliper shows more than any frontal shot. The crystals on the current model are more strongly domed than before, so measure at the highest point.
  • Finish: one report describes the case flank as horizontally brushed and the area between the lugs as vertically brushed. The transitions should be clean.
  • Lugs: curved, the same length on both sides.

The same layout, with the power reserve at 3 and small seconds at 9, also appears on many Big Pilot models, so this thread helps for comparison: IWC Big Pilot IW501004 QC: what to look at. And if you are looking for the chronograph: IWC Portugieser Chronograph QC: subdials, numerals and the railway track.

On the movement: the original has a sapphire caseback, so you can see calibre 52011 with its skeletonised rotor. A photo only shows the look, not the function.

What really says something is a video: wind the crown and watch whether the power-reserve hand moves evenly. How to read such a video, and what it does not prove, is here: power-reserve indicator: what it is, how it looks on a QC video and what it does not prove.

For another IWC, this time with an integrated bracelet: IWC Ingenieur Automatic 40 QC: the grid dial, the five bezel screws and the integrated bracelet.

Recap:

  1. Layout: power reserve at 3, small seconds at 9, date at 6; both subdials the same size, at the same height, cleanly recessed. Judge only on a straight-on photo.
  2. Date window: straight, centred, numeral centred; a fine even lacquer rim is also visible on the original.
  3. Dial: deep lacquer gloss, applied Arabic numerals, leaf-shaped hands; photos without flash.
  4. Case: 42.4 mm, about 13 mm thick, around 48 mm lug to lug; side photo with a calliper; clean transitions in the brushed finish.
  5. Movement: 52011 with 7 days of reserve on the original; a winding video of the power-reserve indicator says more than a caseback photo.
  6. What photos cannot show: the feel of the winding, how long the reserve lasts and timekeeping accuracy.

Editorial summary, not independently verified.

Thanks uhrenfuchs, zeiger_kenner, stahlbandfan and leuchtguru. I’m asking for a straight frontal photo and a winding video.